How to adjust body and slider

The height of the main unit can be adjusted by the following two methods.

• 
• 

Attach lift parts

If the main body does not reach the door surface, please attach the lift part (included) to the main body and adjust the height.

• * Lift parts are shipped as 10mm (x2), 5mm (x1).
• * Phillips screwdriver (not included) is required for installation.
• * Please install using the fixing screw (included).
• * If the door where the lock is be installed is made of metal, magnet lift parts (sold separately) are recommended.

Attach extension slider

If the slider does not reach the thumb turn, please use the extension slider. The width of the slider is adjustable.

* Please align the protrusion of the extension slider (included) with the hole at the end of the slider and push it in.

Close

How to adjust the slider width

You can adjust the slider width fitting the thumb turn of the door, where the lock is to be installed.

Illustration of slider viewed from the front

• * Please adjust width using hexagonal wrench (included)
• * The lock works even if the width of the thumb-turn does not fit perfectly, as long as the thumb-turn is sandwiched tightly between the sliders.

Close

Installation on metal doors

If the door where the lock is to be installed is made of metal, magnet lift parts (sold separately) can also be used.

• * Magnet lift parts are sold separately.
• * Magnet lift parts are 5mm (x1).

Attach magnet lift parts

Please install magnet lift parts (sold separately) to the main body as follows.

• * Phillips screwdriver (not included) is required for installation.
• * Please install using the fixing screw (included).

Close